|
SRHWQ-1 Radiator and
controller for constant temperature
 |
 |
Product Introduction
Temperature controller of model 732¡¢766 can be used to control valves
or those valves or wind doors used in double pipe fan.
Temperature Controller can be applied to turn on or turn off the
valve so as to control the temperature required. It can also be
used to monitor fans. In some cases, controllers can run continuously
or be operated with the fans circularly.
Temperature controllers are equipped with one manual fan switch
of three levels of speed, one switch for coldness and heat, and
the other chief switch for the system.
The temperature can be controlled very accurately as required by
two metal films for film box with air house.
The design of this product is very unique and beautiful which is
very good when installed in indoor environment and very suitable
for use in offices and hotels.
Temperature controller can be installed directly onto walls or into
junction box
Inside the electric circuit in the temperature controller, there
installed an inductor to detect quantity of heat that will improve
the control for cold and warm temperature.
Installation
Temperature controller of model 732¡¢766 are components for temperature
control in the fan and discal pipe or air conditioning system. They
must be installed in a location with open air. The standard height
is 1.5 meter above ground so as to check average temperature. It
should be avoided to install the controller in a wind exit gate
or in a sunny place or a place with cold or heat source. It can
be installed into a standard built-in junction box with dimension
of 75x75x35mm or 55x105x48mm¡£
Technical Specification
Product code 732¡¢766
Deviation at 20.c£¬<1.c
Working range 10-30.c
Temperature inductor film box with air house
Material and color housing and cover are all ivory PC plastics
Rated voltage and electric current 220-240V6(4)A,50-60Hz
Wire connection
The thickest wire that can be accepted for wire connection end is
1.5 mm2.
Transport and storage
Temperature for transport and storage must be controlled within
-20.c to 50.c.
|
